dişli sorunu

Tracey20 tarafından tarihinde yayınlandı

Yeni Sprocket'imi şarj etmeye çalışıyordum. Saatlerdir bağlı. Bağlı olsun ya da olmasın, yalnızca yanıp sönen bir kırmızı ışık alıyorum. Yanıp sönen kırmızı ışığı almak dışında açamıyorum. Sanırım hiç açmadım. Bluetooth'a bağlanamıyorum. Neyi yanlış yapıyorum. Şarj çıkışının yanındaki küçük dikdörtgen kırmızı düğmeden başka bir anahtar yoktur.

← Daha eski gönderi Daha Yeni Gönderi →

2 yorum

  • Thanks for the info, good to know.  Turned out it was the plug, into which I plugged the Sprocket USB.  When I tried another plug, it worked fine.

    üzerinde Tracey20

  • @Tracey20, Welcome to the HP Support Community!
     
    What model HP Sprocket are you using?
     
    Let the printer cool
    The battery might not charge if it is too warm, above 40º C (104º F). Disconnect the printer and let it cool down before you charge it or use it again.

    Turn off the printer, and then disconnect the USB cable.

    Let the printer cool for at least 15 minutes.

    Turn on the printer.

    If the printer does not turn on when you press the Power button, reset the printer to clear any errors.

    Remove the paper cover.

    Locate the Reset button.

    With a paperclip or pin, press and hold the Reset button for 3 seconds.
    The printer resets.

    Replace the paper cover, and then turn on the printer.

     Charge the printer
    The battery might not have enough power to turn on. Charge the printer for at least 30 minutes, disconnect it, and then turn on the printer.

    Connect the USB cable to the printer, and then connect the other end to a power source with at least 2 AMPs, such as a wall adapter or USB-capable power strip.

    Charge the printer for at least 30 minutes or until the Charging Indicator light turns green.

    Disconnect the USB cable from the printer.

    Turn on the printer.

    If the red light is still blinking, perform the steps mentioned in this document. 
     
    Hope this helps! Keep me posted. 
     
    Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.
    Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!
    Have a great day! 

    KUMAR0307 I am an HP Employee
    üzerinde Kumar0307

yorum Yap

Lütfen unutmayın, yorumlar yayınlanmadan önce onaylanmalıdır.