Diagnostic
There are 0 items in your cart
View all items >Sub-totalbefore tax & fees
$0.00
Sprocket 200, bluetooth hakkında hata mesajı veriyor
JBear1 tarafından tarihinde yayınlandı
Sprocket hata mesajı diyor
tüm cihazları sıfırlamayı ve yeniden başlatmayı denedim
Denemek için dedikleri her şeyi denedim ve farklı telefonlarda denedim. Ayrıca bluetooth'u açmamayı da denedim. Bluetooth'un çalışması gerektiğinde cihazı bluetooth'da nasıl unutmak isteyebilir?
← Daha eski gönderi Daha Yeni Gönderi →
@Judge1919, Welcome to HP Support Community!
TEJ1602 I am an HP EmployeeI appreciate your efforts in trying to resolve the issue. Use the document Sprocket Does Not Connect or Print for any additional steps.
If the issue persists, it could be a hardware failure.
Please reach out to the HP Support in your region regarding the service options for your printer.
Hope this helps!
Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!
I am having the same problem and I have tried this and it is still not working. I have tried all other options too. It keeps coming up with an error message when I try to connect saying problem with set up and then the device just disappears of the list in the app. Absolutely pointless asking the virtual agent that was no help whatsoever. Please help!!!
@JBear1, Welcome to HP Support Community!
TEJ1602 I am an HP EmployeeTry a factory reset on the printer-
You can initiate a factory reset by using the steps below. A factory reset can only be completed when the USB charging cable is NOT connected to the printer.
1. Hold the power button for about 7 seconds in total. After 3 seconds, the Status LED light will turn off to indicate the printer is shutting down; continue to hold the Power button until the LED lights start to flash.
2. Release the power button. The LEDs will continue blinking for about 6 seconds.
3. While the LEDs are blinking, press and release the power button. The device will remain off until you power on again. 4. Power on; the printer will be reset to factoring settings. After a factory reset, all settings are reset to factory defaults (Custom Name, LED color, Sleep Time, Auto-Off, etc.)
Now try connecting.
Hope this helps! Keep me posted.
Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!