Şarj olurken yanıp sönen ışıklar

Brooke4793 tarafından tarihinde yayınlandı

Sadece dün zincir dişlimi getirdim ve 3 saatten fazla şarj etmesine izin verdim, ölmeden önce 3 fotoğraf basabildim. Yeniden şarj ettim ve bir kenara koydum ve bu sabah denemeye ve kullanmaya gittiğimde bile açılıyordu. Bugün zincir dişlisini şarja taktığımda LED ışığı aynı anda kırmızı ve yeşil renkte yanıp sönüyor ve kabloyu çıkarır çıkarmaz ölüyor. Uygulamaya göre zincir dişlisini bağladığımda %100 pil var diyor. kafam çok karışık ve sinirliyim lütfen biri yardım etsin

← Daha eski gönderi Daha Yeni Gönderi →

3 yorum

  • Thanks for the reply and trying the suggested steps, the issue you are facing seems to be a hardware issue, recommend you contact our phone support for the service options available. 
     
    Keep me posted. Good Luck. 

    Chimney_83 I am an HP Employee
    üzerinde Chimney_83

  • Hi, thanks for getting back to me. Unfortunately I have done the things you recommended and the light is still flashing red and green and it will not hold charge.

    üzerinde Brooke4793

  • Hi! @Brooke4793, Thank you for visiting the HP Forums! A great place where you can find solutions for your issues, with help from the community! I understand when you plug the sprocket to charge LED light is flashing red and green. Don’t worry I’ll try to help you out. Did you make any changes to your printer? Try the steps recommended below. Please try few steps recommended below. 1.    Reset the Sprocket unit by placing a push-pin or needle into the small hole on the rear of the unit.  (Reset instructions in the support doc HERE)
    2.    Plug in the Sprocket unit with the provided micro-USB cable.  Connect to either a computer USB port or USB wall charger.
    3.    Allow the Sprocket unit to charge for 10 minutes.  Note:  A call back may be required in these instances.
    4.    Power on the Sprocket unit by pressing/holding the power button for 3 seconds.
    5.    A white LED should illuminate on the rear of the unit if power up is successful.
    6.    Remind the customer to charge their Sprocket for an additional 60-90 minutes to enable a full battery charge.
      If the issue still persists uninstall the sprocket app and reinstall the app and try updating the sprocket firmware from the sprocket app and check if it helps. Open Sprocket app go to menu—>Sprocket—→ Printers; A blue firmware update link will be present if an update is available. Refer this article to know more information about using sprocket printer. Also, refer the printer user guide for more information. If the issue persists after trying out the steps, please contact HP support for service options. Link to contact HP.  Let me know if this helps!Have a pleasant day ahead! 🙂  Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.                                                                                                                  Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

    A4Apollo I am an HP Employee
    üzerinde A4Apollo

yorum Yap

Lütfen unutmayın, yorumlar yayınlanmadan önce onaylanmalıdır.