スプロケットが機能しない

I18n Error: Missing interpolation value "x" for "投稿者 |@plgn|{{ x }} |plgn@| on |@plgn|{{ x }} |plgn@|"

みんながIOS 11.2で抱えていたような問題私は今アンドロイドで自分自身を経験しています。プリンターを動作させるために複数のAndroidデバイスですべてを試しましたが、接続できず、すべてをリセットしてインストールとアンインストールを行っても更新などを実行できないため、これを修正してください。複数回。このプリンタを1か月だけ持っていた。以前は機能していましたが、今は返品期間が過ぎても機能しません。そうでなければこれは無駄なお金なので、誰かが何かを提案するのを手伝ってもらえますか？

← 古い投稿 新しい投稿 →

I18n Error: Missing interpolation value "x" for "|@plgn|{{ x }} |plgn@| コメント"

  • Hi! @amber96, Thank you for visiting the HP Forums! A great place where you can find solutions for your issues, with help from the community!
     
    I understand you have issues connecting your IOS device to the sprocket printer.
     
    Don’t worry I’ll try to help you out.
     
    Did you make any changes to your printer?
     
    As you mentioned you have issues connecting your IOS device to the sprocket printer.
     
    Try the steps recommended below.
     
    Please try few steps recommended below.
     
    1.    Reset the Sprocket unit by placing a push-pin or needle into the small hole on the rear of the unit.  (Reset instructions in the support doc HERE)
    2.    Plug in the Sprocket unit with the provided micro-USB cable.  Connect to either a computer USB port or USB wall charger.
    3.    Allow the Sprocket unit to charge for 10 minutes.  Note:  A call back may be required in these instances.
    4.    Power on the Sprocket unit by pressing/holding the power button for 3 seconds.
    5.    A white LED should illuminate on the rear of the unit if power up is successful.
    6.    Remind the customer to charge their Sprocket for an additional 60-90 minutes to enable a full battery charge.
     
     
    If the issue still persists uninstall the sprocket app and reinstall the app and try updating the sprocket firmware from the sprocket app and check if it helps.
     
    Open Sprocket app go to menu—>Sprocket—→ Printers; A blue firmware update link will be present if an update is available.
     
    Also, unpair the sprocket from your smartphone and add the printer again and check if it helps.
     
    Refer this article to know more information about using sprocket printer.
     
     
    If the solution provided worked for you, please mark accepted solution for this post.
     
    Let me know if this helps!
    Have a pleasant day ahead! 🙂
     
     
    Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.
                                                                                                                      
    Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

    A4Apollo I am an HP Employee
    I18n Error: Missing interpolation value "x" for "|@plgn|{{ x }} |plgn@| on |@plgn|{{ x }} |plgn@|"

コメントを残す

コメントは公開前に承認される必要があることに注意してください