La ruota dentata non si spegne né stampa

Inserito da kotaelliott10 su

Possiedo una Sprocket 200. Stavo stampando molte immagini e ha smesso di stampare. Ho deciso di provare a spegnerlo e poi riaccenderlo. Ora al momento non si spegne.


Post più vecchio Post più recente

2 commenti

  • I am trying to turn my sprocket off but it just keeps flashing red. I have tried holding the button on the back near the charging part. But that is not working.

    Olivia Gray su
  • @kotaelliott10 Hello,In order to palliate this issue, please reset the printer as follows:Make sure the printer is on.Remove the paper cover.Locate the Reset button.With a paperclip or pin, press and hold the Reset button until the Charging Indicator light turns off.The printer resets and turns off.Replace the paper cover, and then turn on the printer.I remain at your disposal in case of need.Best regards,

    I’m not an HP employee. Did this message answer your question? Include it below as an Accepted Solution! Did you find this message useful?  Click on the thumbs up set to give a Compliment! Follow us on Facebook Assistance customers HP.

    Mans su

lascia un commento