Le pignon ne charge pas

Publié par Mom2Lu le

Sprocket ne chargera pas. Le voyant rouge s'allume lorsque vous le branchez, mais s'éteint après quelques secondes et ne fera rien. Ne s'allume pas, ne charge pas. Rien

Article plus ancien Message plus récent

1 commentaire

  • @Mom2Lu, Welcome to HP Support Community!
    I see that you’re unable to charge the printer or power it on. Try the steps below and see if that makes a difference-
    Use a different USB cable to charge the device. Also, try resetting the printer.

    Turn on the Sprocket.

    Remove the Paper Cover, and then use a narrow object, such as a pen or paperclip, to press and hold the Reset button for 3 seconds until the Sprocket turns off.
    The location of the Reset button varies by Sprocket model. Typically, the button is located underneath the Paper Cover, but can also be found on the outside next to the charging port.

    Example of resetting the HP Sprocket Select Photo Printer

    Turn on the Sprocket.

    Keep me posted.
    Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

    TEJ1602 I am an HP Employee
    TEJ1602 le

laissez un commentaire

Veuillez noter que les commentaires doivent être approuvés avant d'être publiés