Diagnostic
There are 0 items in your cart
View all items >Sub-totalbefore tax & fees
$0.00
Pignon HP indiquant que le couvercle en papier n'est pas en place
Publié par kaylee-k le
Salut! Mon pignon HP continue de clignoter en rouge et de dire que le couvercle n'est pas allumé. J'ai essayé de réinitialiser le pignon, de mettre à jour l'application, de mettre du nouveau papier et de recharger le pignon, mais rien ne semble fonctionner
← Article plus ancien Message plus récent →
@kaylee-k
Welcome to the HP support community.
Turn off the Sprocket, and then remove the paper cover.
Remove any loose photo paper from the input tray, and then make sure the photo paper is in good condition. Remove any severely bent, wrinkled, or torn photo paper from the stack.
CAUTION:
Do not try to remove any jammed paper from inside the paper path. This can damage the paper path rollers.
Turn on the Sprocket.
If there is jammed photo paper, the Sprocket feeds it through the output slot.
Wait until the Sprocket is idle and silent, and then remove any photo paper fed through the output slot.
Reload the photo paper with the HP logos facing down. Make sure to load genuine Sprocket photo paper, or the Sprocket might not print.
Replace the paper cover, and then resend the print job.
You can refer this HP document for more assistance:- Click here
Sandytechy20 I am an HP EmployeeI hope that helps.
To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.
Cheers.