No se conecta a la aplicación a pesar de que está conectado a bluetooth

Publicado por Molly36 en




mi rueda dentada está conectada a bluetooth pero aún no se conecta a la aplicación. lo he intentado todo


encuentra el dispositivo en la lista, pero luego dice «problema con la configuración»


Entrada antigua Publicación más reciente

1 comentario

  • @Molly36, Welcome to HP Support Community!
    Check if the sprocket is paired in the Bluetooth settings
    Update the Sprocket app to the latest version.
    If the issue persists, you can initiate a factory reset by using the steps below. A factory reset can only be completed when the USB charging cable is NOT connected to the printer.
    1. Hold the power button for about 7 seconds in total. After 3 seconds, the Status LED light will turn off to indicate the printer is shutting down; continue to hold the Power button until the LED lights start to flash.
    2. Release the power button. The LEDs will continue blinking for about 6 seconds.
    3. While the LEDs are blinking, press and release the power button. The device will remain off until you power on again. 4. Power on; the printer will be reset to factoring settings. After a factory reset, all settings are reset to factory defaults (Custom Name, LED color, Sleep Time, Auto-Off, etc.)
    Hope this helps! Keep me posted. 
    Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

    TEJ1602 I am an HP Employee
    TEJ1602 en

Deja un comentario