HP Sprocket dice que la tapa de papel no está puesta

Publicado por kaylee-k en

¡Hola! Mi HP Sprocket sigue parpadeando en rojo y dice que la tapa no está puesta. Intenté restablecer la rueda dentada, actualizar la aplicación, colocar papel nuevo y recargar la rueda dentada, pero nada parece funcionar.

Entrada antigua Publicación más reciente

1 comentario

  • @kaylee-k
    Welcome to the HP support community.

    Turn off the Sprocket, and then remove the paper cover.

    Remove any loose photo paper from the input tray, and then make sure the photo paper is in good condition. Remove any severely bent, wrinkled, or torn photo paper from the stack.
    Do not try to remove any jammed paper from inside the paper path. This can damage the paper path rollers.

    Turn on the Sprocket.
    If there is jammed photo paper, the Sprocket feeds it through the output slot.

    Wait until the Sprocket is idle and silent, and then remove any photo paper fed through the output slot.

    Reload the photo paper with the HP logos facing down. Make sure to load genuine Sprocket photo paper, or the Sprocket might not print.

    Replace the paper cover, and then resend the print job.

    You can refer this HP document for more assistance:- Click here
    I hope that helps.
    To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

    Sandytechy20 I am an HP Employee
    sandytechy20 en

Deja un comentario

Tenga en cuenta que los comentarios deben aprobarse antes de que se publiquen