It won’t connect to the app even though it’s connected to bluetooth

Posted by Molly36 on

2B93DC86-15DB-490D-953E-1A533178C7E2.jpeg

AA3D5FC9-D142-45E9-8CC4-0E3363D23C5B.jpeg

Hi!

my sprocket is connected to bluetooth but it still won’t connect to the app. I have tried everything

 

it finds the device in the list but later it says “problem with setting”

 


Older Post Newer Post

1 comment

  • @Molly36, Welcome to HP Support Community!
     
    Check if the sprocket is paired in the Bluetooth settings
    Update the Sprocket app to the latest version.
     
    If the issue persists, you can initiate a factory reset by using the steps below. A factory reset can only be completed when the USB charging cable is NOT connected to the printer.
    1. Hold the power button for about 7 seconds in total. After 3 seconds, the Status LED light will turn off to indicate the printer is shutting down; continue to hold the Power button until the LED lights start to flash.
    2. Release the power button. The LEDs will continue blinking for about 6 seconds.
    3. While the LEDs are blinking, press and release the power button. The device will remain off until you power on again. 4. Power on; the printer will be reset to factoring settings. After a factory reset, all settings are reset to factory defaults (Custom Name, LED color, Sleep Time, Auto-Off, etc.)
     
    Hope this helps! Keep me posted. 
     
    Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

    TEJ1602 I am an HP Employee
    TEJ1602 on

Leave a comment