Sprocket 200 won’t charge

Posted by Worlo on

I’ve not used my sprocket for a few months. I’ve had it on charge for 2 days now - after a while the red light goes out so I unplug it. If I re-plug it in, the red light comes back on again for a while but then goes out again. Help!!

Older Post Newer Post

1 comment

  • Hi @Worlo
    Welcome to the HP Support Community. I’d be happy to assist you with the blinking LED.
    Let’s try these steps - 
    The battery might not charge if it is too warm, above 40º C (104º F). Disconnect the printer and let it cool down before you charge it or use it again.

    1.) Turn off the printer, and then disconnect the USB cable.
    2.) Let the printer cool for at least 15 minutes.
    3.) Turn on the printer.
    If the printer still does not turn on, the battery might not have enough power to turn on. Charge the printer for at least 30 minutes, disconnect it, and then turn on the printer.

    1.) Connect the USB cable to the printer, and then connect the other end to a power source with at least 2 AMPs, such as a wall adapter or USB-capable power strip.
    2.) Charge the printer for at least 30 minutes or until the Charging Indicator light turns green.
    3.) Disconnect the USB cable from the printer and try turning on the printer.
    If this does not fix the issue, please try the reset -
    1.) Hold the power button for about 7 seconds total. After 3 seconds, the Status LED light will turn off to indicate the printer is shutting down; continue to hold the Power button until the LED lights start to flash.
    2.) Release the power button. The LEDs will continue blinking for about 6 seconds.
    3.) While the LEDs are blinking, press and release the power button. The device will remain off until you power on again. 4. Power on; the printer will be reset to factoring settings. After a factory reset, all settings are reset to factory defaults (Custom Name, LED color, Sleep Time, Auto-Off, etc.) 
    Hope this helps! Keep me posted. 
    Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.
    Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!
    Have a great day! 

    Asmita I am an HP Employee
    asmita6658 on

Leave a comment

Please note, comments must be approved before they are published