About the hp 50g Display Modes...

Posted by Naakkeli on



Can anybody helps me... can I set the hp 50g Display Mode so that it shows the '0' before the comma/point in number - in other words that '0.5' is '0.5', NOT '.5' (without 0 before the comma/point)?

Older Post Newer Post


  • Unfortunately NOT helps…! 😞

    Naakkeli on
  • @Naakkeli The following manual may help      http://www.hpgraphingcalc.org/uploads/9/4/3/8/9438994/hp_50g_user_guide.pdf Regards.

    BH*****Click the KUDOS thumb up on the left to say ’Thanks’**Make it easier for other people to find solutions by marking a Reply ‘Accept as Solution’ if it solves your problem.

    banhien on

Leave a comment

Please note, comments must be approved before they are published